Gel for strengthening natural nails F.O.X / Shine Gel / Milk, 15 ml (jar)
- Manufacturer: F.O.X
- Item SKU: 227564
- In stock
- 330.00 грн.
F.O.X Shine GeI Milk is an updated formula of the famous F.O.X Smart gel. Liquid gel of the three-phase system for strengthening nails, has a gentle camouflaging pink shade with fine shimmer.
The material does not require sawing.
Due to the low level of acidity, it is absolutely safe for the nail plate.
Suitable for thin and sensitive nails.
Shine GeI has a medium viscosity. Perfectly aligns and strengthens both short and long nails. Does not deform during wear, retains the perfect shine until correction.
It is recommended to make the substrate with a thin layer of elastic base F.O.X Base Rubber or F.O.X Base Power for better adhesion to the nail plate.
With the updated Shine GeI, you can make the surface of the nail bright with an intense shimmer of sparkles - for this, you should stir the material with an orange stick before use, and if the client wants to get a delicate and barely noticeable "shimmer", use the gel without mixing it in the jar.
APPLICATION TECHNOLOGY
Standard preparation of the nail plate
1. Apply F.O.X Nail Prep degreaser to the damaged surface of the nail;
2. Apply F.O.X Ultrabond — an acid-free primer for additional adhesion;
3. Apply a layer of elastic base (F.O.X Base Power, F.O.X Base Rubber or F.O.X Air Base) with rubbing movements and dry in a UV lamp 36W - 2 minutes, LED/UV lamp 36/48W - 60 seconds.
4. Apply Shine gel Milk in a thin layer, distributing it over the entire nail plate.
5. Put a drop on the non-dried layer, build the architecture of the nail and form a reflection.
Dry in a 36W UV lamp for 2 minutes, 36/48W LED/UV lamp for 60 seconds.
6. Nails are ready for application of gel polish or top.
Additional recommendations:
If the client wants to leave the nails without gel polish, after drying Shine GeI Milk, a top coat should be applied. If you want to cover with gel varnishes, or make a design — for better results and clean lines, we advise you to remove the dispersive layer beforehand.